P-CUBEs – The Die Has Been Cast!
Photodiode Modules for Direct Application on an Optical Bench
US29-255
Precise measurement technology in a compact measurement setup: this describes the new P-CUBEs!
Low-noise, sensitive PIN photodiodes are housed in cubes. The CUBEs have an edge length of only 40 mm. To integrate them into optomechanical setups, the CUBEs can be attached to a rod system.
The following versions are available:
- GaP photodiode
Particularly low noise;
sensitivity: 190 – 570 nm - Si photodiode
Enhanced in the blue spectral range;
sensitivity: 200 –1050 nm - InGaAs PIN photodiode
Enhanced in the NIR;
sensitivity: 800 – 2200 nm
The photocurrent is obtained using a BNC connector. The P-CUBE is also available with an optical FC connector.
iAMP-700.
The programmable iAMP-700 current amplifier is directly connected to the P-CUBE with a BNC connector. It is possible to achieve amplifications of 102-1011 V/A with the iAMP-700.
P-CUBE & iAMP – A Strong Combination
By combining the P-CUBE and iAMP-700, the smallest amount of light can be detected reliably. The iAMP’s EMC housing allows application in close proximity to the source. The P-CUBEs require a bias voltage between -10 V and +10 V. This can be obtained directly from the iAMP.
Further product information:
Manufacturer:
LASER COMPONENTS Germany / Electronics Production
Contact:
Contact Person: | Matt Robinson |
Company: | LASER COMPONENTS USA Inc. |
Address: | 116 South River Road Building C |
ZIP / City: | 03110 Bedford, NH |
Phone: | +1 603 821 7040 |
Fax: | +1 603 821 7041 |
Email: | sales@laser-components.com |
|